POSITION TRACKING CONTROL OF DC MOTOR FOR FRONT WHEEL SYSTEMS VIA HILS SIMULATION METHOD

M.F. A. Aili, F. Ahmad, M.H. Che Hasan, M.H. Harun, M.H. Harun

Abstract


This paper present about position tracking control of DC motor to be used as the actuator controller for the front wheel test rig system. The controller strategy that was developed is based on Proportional-Integral-Derivative (PID) controller. It consists of one single closed control loops namely position tracking control loop.  To evaluate the effectiveness of the proposed controller, simulation and experimental studies were performed by using various input demand such as saw tooth, sine and step functions in 5°, 10°, 15° and 20° with the present of steering ratio at 360:20. The results, it is found that the trend between simulation and experimental data are similar with the command position with acceptable level of error which less than 10% for application at hand.

Full Text:

PDF

References


Kim, J., Jo, C., Kwon, Y., Cheon, J. S., Park, S. J., G. Jeon, B., Shim, J. (2014). “Electromechanical brake for front wheel with backup braking”. SAE International Journal of Passenger cars – Mechanical System, 7(4), pp. 1369-1373.

Haggag, S., Abidou, D. (2013). An approach to vehicle brake-by-wire optimal control tracking strategy. SAE International Journal of Passenger Cars – Mechanical System, 6(1), pp. 154-162.

Abd. Rahman, M. L. H., Hudha, K., Ahmad, F., Jamaludin, H. (2013). Design and clamping force modeling of electronic wedge brake system for automotive application. International Journal of Vehicle Modeling and Testing (IJVSMT), 8(2), pp. 145-156.

Robert Bosch GmbH, (2014), “Bosch automotive electrics and automotive electronics: Systems and components,” in Networking and Hybrid Drive. Plochingen, Germany: Springer-Verlag.

S. A. Arogeti, D. Wang, C. B. Low, and M. Yu, (2012) “Fault detection isolation and estimation in a vehicle steering system,” IEEE Trans.Ind. Electron., 59(12), pp. 4810–4820.

Aparow, V. R., Hudha, K., Ahmad, F., Jamaluddin, H. (2014). Model in the loop simulation of gap and torque tracking control using electronic wedge brake, International Journal of Vehicle Safety (IJVS), 7(3/4), pp. 390 – 408.

Han, K. Kim, M., Huh, K. (2012). Modeling and Control of an Electronic Wedge Brake. Proceeding of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science, 226(10), pp. 2440-2455.

Emam, M. A. A., Emam, A. S., El-Demerdash,S. M., Shaban S. M., Mahmoud, M. A. (2012). Performance of Automotive Self-reinforcement Brake System. Journal of Mechanical Engineering, 1(1), pp. 4–10.

Castaneda, C. E., Lopez-Mancilla, D., Garcia, J. H., Reategui, R. J., Huerta, G. and Zarate, R. C. (2010). Position Control of DC motor Based on Recurrent High Order Neural Networks. IEEE Proceeding on International Symposium on Intelligent Control, Part of 2010 IEEE Multi-Conference on Systems and Control. September 8-10, Yokohama, Japan, pp.1-6.

M. Ren, J. Zhang, H. Yue, and S. Zhou (2016), “Adaptive neural network cascade control system with entropy-based design,” IET Control Theory Appl., 10(10), pp. 1151–1160.

C. Jauregui, M. Duarte Mermoud, G. Lefranc, R. Orostica, J. C. Travieso Torres, and O. Beytia (2016), “Conical Tank Level Control with Fractional PID,” IEEE Lat. Am. Trans., 14(6), pp. 2598–2604.

A. S. Bazanella, L. F. A. Pereira, and A. Parraga (2017), “A New Method for PID Tuning Including Plants Without Ultimate Frequency,” IEEE Trans. Control Syst. Technol., 25(2), pp. 637–644.

J. Fei, Y. Chu, and S. Hou (2017), “A Backstepping Neural Global Sliding Mode Control Using Fuzzy Approximator for Three-Phase Active Power Filter,” IEEE Access, 5, pp. 16021–16032.

J.-H. Yang and H.-K. Xu (2018), “Robust Controller Design for NonMinimum Phase UAV System and System Analysis,” IEEE Access, 6, pp. 70734–70769.

A. Bisoffi, M. Da Lio, A. R. Teel, and L. Zaccarian (2018), “Global Asymptotic Stability of a PID Control System with Coulomb Friction,” IEEE Trans. Automat. Contr., 63(8), pp. 2654–2661.

S. Han and S. P. Bhattacharyya (2018), “PID Controller Synthesis Using a -Hurwitz Stability Criterion,” IEEE Control Syst. Lett., 2(3), pp. 525–530.

J. Wang, Z. Luo, Y. Wang, B. Yang, and F. Assadian (2018), “Coordination Control of Differential Drive Assist Steering and Vehicle Stability Control for Four-Wheel-Independent-Drive EV,” IEEE Trans. Veh. Technol., 67(12), pp. 11453–11467.

T. MohammadRidha et al. (2018), “Model Free iPID Control for Glycemia Regulation of Type-1 Diabetes,” IEEE Trans. Biomed. Eng., 65(1), pp. 199–206.

V. Gholamrezaie, M. G. Dozein, H. Monsef, and B. Wu (2018), “An Optimal Frequency Control Method Through a Dynamic Load Frequency Control (LFC) Model Incorporating Wind Farm,” IEEE Syst. J., 12(1), pp. 392–401.

Amir M.Z. and Abd Samad M.F (2016), “Hardware-in-the-loop simulation of steer-by-wire system in automotive vehicle” International Journal of Advanced and Applied Sciences, 3(9), pp. 51-58.

Jadoun, R & Choudhary, Sushil. (2014)“Design and fabrication of variable steering ratio mechanism for light Motor vehicle”. Innovative system Design & Engineering, 5, pp. 7-15.




DOI: http://dx.doi.org/10.2022/jmet.v15i1.6319

PRINT ISSN No.: 2180-1053
E ISSN No.: 2289-8123