Characterization and Behavior Analysis of a Thermoelectric Module Energy Harvesting System Exposed to Transient Sourcess

A. M. Yusop, R. Mohamed, A. Ayob, A. Mohamed

Abstract


This study presents a characterization and analytical study on the behavioral analysis of a thermoelectric module (TEM) energy harvesting system. TEM was applied with transient sources to both of its sides with two different configurations, single TEM and multi-stage TEM, which were electrically connected in series and thermally in parallel. The output voltage of the TEM was harvested from the heat of the hotplate. Previous studies have focused on the steady-state analysis of a single TEM. In real applications, the temperature of both ends fluctuates with time. In this study, a MATLAB model of TEM was presented with the addition of a transient condition. A test rig was developed to configure the transient behavior of different TEM configurations. Both experimental and simulation data show that the multi-stage configuration of TEM could generate electricity with a maximum operating point at a test temperature of 50°C to 100°C. This maximum operating point was strongly influenced by the constancy of the thermal gradient of TEM. This finding is very useful in order to determine the best temperature range that TEM can work before it is applied to any medium to harvest energy. Multi stage TEM arrangement electrically in series and thermally in parallel has obtained the highest output voltage up to 0.115 V for six cascaded TEM compared to the other three tested circuit arrangements.

Keywords


Energy Harvesting System; Dynamic Transient Sources; Thermoelectric Module.

Full Text:

PDF

References


X.-D. Wang, Q.-H. Wang, and J.-L. Xu, “Performance analysis of two-stage TECs (thermoelectric coolers) using a three-dimensional heat-electricity coupled model,” Energy, no. 0, 2013.

S. Sharma, V. Dwivedi, and S. Pandit, “A Review of Thermoelectric Devices for Cooling Applications,” International Journal of Green Energy, 2013.

H. Schock, G. Brereton, E. Case, J. D’Angelo, T. Hogan, M. Lyle, R. Maloney, K. Moran, J. Novak, and C. Nelson, “Prospects for Implementation of Thermoelectric Generators as Waste Heat Recovery Systems in Class 8 Truck Applications,” Journal of Energy Resources Technology, vol. 135, pp. 22-31, 2013.

B. Karthikeyan, D. Kesavaram, S. A. Kumar, and K. Srithar, “Exhaust energy recovery using thermoelectric power generation from a thermally insulated diesel engine,” International Journal of Green Energy, 2012.

X.-Y. Han, and J. Wang, “Effect of Mach number on thermoelectric performance of SiC ceramics nose-tip for supersonic vehicles,” Applied Thermal Engineering, vol. 62, no. 1, pp. 141-147, 2014.

P. R. d. C. Merschmann, E. Vasquez, A. S. Szklo, and R. Schaeffer, “Modeling water use demands for thermoelectric power plants with CCS in selected Brazilian water basins,” International Journal of Greenhouse Gas Control, vol. 13, pp. 87-101, 2013.

R. Y. Nuwayhid, A. Shihadeh, and N. Ghaddar, “Development and testing of a domestic woodstove thermoelectric generator with natural convection cooling,” Energy Conversion and Management, vol. 46, no. 9–10, pp. 1631-1643, 2005.

K. Ghali, N. Ghaddar, and M. Salam, “Radiant domestic combustion stove system: Experimental and simulated study of energy use and thermal comfort,” International journal of green energy, vol. 2, no. 3, pp. 287-306, 2005.

A. Srivastava, D. Duran, M. Pinder, V. Raghav, and N. Komerath, "Conceptual design of a thermoelectric Edu-Kitchen system." pp. 1-6.

W. Zhao, K. Choi, S. Bauman, T. Salter, D. A. Lowy, M. Peckerar, and M. K. Khandani, “An energy harvesting system surveyed for a variety of unattended electronic applications,” Solid-State Electronics, vol. 79, no. 0, pp. 233-237, 2013.

R. Bonin, D. Boero, M. Chiaberge, and A. Tonoli, “Design and characterization of small thermoelectric generators for environmental monitoring devices,” Energy Conversion and Management, vol. 73, no. 0, pp. 340-349, 2013.

A. Martínez, D. Astrain, and A. Rodríguez, “Dynamic model for simulation of thermoelectric self cooling applications,” Energy, vol. 55, no. 0, pp. 1114-1126, 2013.

J.-H. Meng, X.-X. Zhang, and X.-D. Wang, “Dynamic response characteristics of thermoelectric generator predicted by a three-dimensional heat-electricity coupled model,” Journal of Power Sources, vol. 245, no. 0, pp. 262-269, 2014.

J.-H. Meng, X.-D. Wang, and X.-X. Zhang, “Transient modeling and dynamic characteristics of thermoelectric cooler,” Applied Energy, vol. 108, no. 0, pp. 340-348, 2013.

W.-H. Chen, C.-Y. Liao, and C.-I. Hung, “A numerical study on the performance of miniature thermoelectric cooler affected by Thomson effect,” Applied Energy, vol. 89, no. 1, pp. 464-473, 2012.

S. Lineykin, and S. Ben-Yaakov, “Analysis of thermoelectric coolers by a spice-compatible equivalent-circuit model,” Power Electronics Letters, IEEE, vol. 3, no. 2, pp. 63-66, 2005.

C.-T. Hsu, G.-Y. Huang, H.-S. Chu, B. Yu, and D.-J. Yao, “An effective Seebeck coefficient obtained by experimental results of a thermoelectric generator module,” Applied Energy, vol. 88, no. 12, pp. 5173-5179, 2011.

J. P. Carmo, J. Antunes, M. F. Silva, J. F. Ribeiro, L. M. Goncalves, and J. H. Correia, “Characterization of thermoelectric generators by measuring the load-dependence behavior,” Measurement, vol. 44, no. 10, pp. 2194-2199, 2011.

Z. Huajun, C. Hao, W. Jun, T. Wenquan, L. Hongjun, and P. Liang, “Research on the generating performance of series-parallel connection and reappearance of a semiconductor thermoelectric module,” Acta Energiae Solaris Sinica, vol. 22, pp. 394-397, 2001.

N. Q. Nguyen, and K. V. Pochiraju, “Behavior of thermoelectric generators exposed to transient heat sources,” Applied Thermal Engineering, vol. 51, no. 1–2, pp. 1-9, 2013.

A. M. Yusop, R. Mohamed, and A. Ayob, "Model building of thermoelectric generator exposed to dynamic transient sources." p. 012015.

H.-L. Tsai, and J.-M. Lin, “Model Building and Simulation of Thermoelectric Module Using Matlab/Simulink,” Journal of Electronic Materials, vol. 39, no. 9, pp. 2105-2111, 2010.

G. Liang, J. Zhou, and X. Huang, “Analytical model of parallel thermoelectric generator,” Applied Energy, vol. 88, no. 12, pp. 5193-5199, 2011.


Refbacks

  • There are currently no refbacks.


Creative Commons License
This work is licensed under a Creative Commons Attribution 3.0 License.

ISSN: 2180-1843

eISSN: 2289-8131