Design and Development of Low Cost Two Axis Filament Winding Machine
Composite materials are been used in many applications these days, as they have demonstrated there competence and sustainability to considerable distance. Among the various manufacturing techniques filament winding method is the cheap and easy way of fabrication symmetric components. The present work focuses on design and development of a low cost two axis laboratory size filament winding machine (FWM) capable of developing pipes of 50 mm minimum internal diameter and a maximum length of 1000mm. The speed control units developed in the present study facilitates in independently controlling the speeds and direction of the mandrel and the end-effecter in an attempt to achieve the winding angle ranging from 10º to 90º. The speed of the mandrel and the end – effecter could be varied from 0 – 480 rpm and 0 – 500 rpm respectively. A 16-bit RISC single-chip microcontroller is used to logically process the required control signals to achieve the required the motion in the machine. Tubular samples of 50 mm internal diameter and 53mm external diameter were prepared from the developed FW machine and where with a good product quality.
Frank C. Shen, “A filament-wound structure technology overview”, Materials Chemistry and Physics 42 (1995) 96-100
Shaiq A. Haq, 1994 “Filament Winding Machine Control Using B-Spline Interpolation”, Ph.D. thesis, University of Nottingham, Nottingham NG7 2RD, United Kingdom.
M.Munro, “Review of Manufacturing of Fiber Composite Components by Filament Winding”, Polymer Composites, October 1988, Vd. 9, No. 5, 352-359.
S.W. Lye, F.Y.C, Boey, “Development of a low-cost prototype filament-winding system for composite components”, Journal of Materials Processing Technology 52 (1995) 570 584
F.H. Abdalla, S.A. Mutasher, Y.A. Khalid, S.M. Sapuan , A.M.S. Hamouda, B.B. Sahari, M.M. Hamdan, “Design and fabrication of low cost filament winding machine”, Materials and Design 28 (2007) 234–239J.
M. Lossie and H. Van Brussel, “Design principles in filament winding”, Composites Manufacturing Vol 5 No 1 1994, 5 -13.
D. Shaw-Stewart, “Filament Winding- Materials & Engineering”, Materials & Design Vol. 6 No. 3 June/July 1985, 140-144.
Saad Mutasher*, Nazim Mir-Nasiri, Lee Chai Li, “Small-Scale Filament Winding Machine For Producing Fiber Composite Products”, Journal of Engineering Science and Technology, Vol. 7, No. 2 (2012) 156 – 168.
Haisheng Lia, Youdong Liang, Hujun Bao, “CAM system for filament winding on elbows”, Journal of Materials Processing Technology 161 (2005) 491–496.
Johan Scholliers and Hendrik Van Brussel, “Computer-INTEGRATED FILAMENT WINDING: COMPUTER-INTEGRATED DESIGN, ROBOTIC filament winding and robotic quality control”, Composites Manufacturing Vol 5 No 1 1994, 15-23.
Takashi Imamura, Tetsuya Kuroiwa, Kazuhiko Terashima & Hidehiro Takemoto, “Design and Tension Control of Filament Winding System”, IEEE International Conference on Systems, Man, and Cybernetics, 1999. IEEE SMC ‘99, 12-15 Oct. 1999, Tokyo, Japan.
© Journal of Advanced Manufacturing Technology